You are here

Equivocate and Studio One

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

4 posts / 0 new
Last post
nmscapegoat
Joined: Sep 12 2018
Posts: 2

Equivocate and Studio One

September 12, 2018 - 09:51 am

Anybody using Equivocate to master in Studio one?  I'm trying to EQ match a few songs in the Project Page of S1 and can't figure out how to sidechain during mastering process.

DGillespie's picture
Eventide Staff
DGillespie
Joined: Jan 29 2008
Posts: 976
September 12, 2018 - 09:52 am

nmscapegoat wrote:

Anybody using Equivocate to master in Studio one?  I'm trying to EQ match a few songs in the Project Page of S1 and can't figure out how to sidechain during mastering process.

Hi nmscapegoat,

I just replied to your email, but I'll copy my response here in case anyone else has a similar question:

You will need to load a wav file of the reference song into the session you’re trying to match.  Then you can mute the reference song in the master bus, but route it to the sidechain.  Does that make sense?

Thanks,

Dan

nmscapegoat
Joined: Sep 12 2018
Posts: 2
September 12, 2018 - 06:09 pm

Thanks.  I was trying to use it in the project page, but I guess it isn't supported in that area.  So I'm going through each individual song, using EQ match there, then sending them to the project page.

DGillespie's picture
Eventide Staff
DGillespie
Joined: Jan 29 2008
Posts: 976
September 12, 2018 - 09:14 pm

nmscapegoat wrote:

Thanks.  I was trying to use it in the project page, but I guess it isn't supported in that area.  So I'm going through each individual song, using EQ match there, then sending them to the project page.

 

I'm not sure I understand what you mean by, "and sending them to the project page", but it sounds like you have it working?