You are here

4.0 issues

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

4 posts / 0 new
Last post
davestejna
Joined: May 12 2008
Posts: 4

4.0 issues

davestejna
October 23, 2009 - 02:00 pm

I did the update - went smoothly. Cleared setup as recommended. Reconfiged Setup manually. Put back in my memory card that I've been using fine for 2 years. For some reason even though it says 'updating program files' I have none of my saved programs. Nothing exists in the 500 bank. I did nothing other then swap cards with my update card. 

Tried putting the mem card on computer - and re copied my backup up folder that I saved on there back to it it and tried again - nothing. (I had backed it up by copying the contents of the mem card to a folder on my comp) 

Any suggestions?

Also, getting freezes now bad too. As my main solo patch I use is Vintage DDL - I pulled up #189 - tweaked the FB a bit, set to 'Vintage' then every single time I try to modulate the Send button by holding it - the unit freezes. I assign a footpedal to Send to control my delay send live. So I'm kinda dead in the water here if I can't figure this one out. Any help would be accepted. Thanks.

IDeangelis
Joined: Jan 9 2008
Posts: 1470
IDeangelis
October 23, 2009 - 02:47 pm

Hi

the freezes occurring on trying to modulate parameters is a known bug in V4.0. We are working on a fix. You will find info on this in recent posts.

As for your presets not showing up, you may try reformatting the card and let the Eclipse create the PGM folder on it by storing a factory preset on the card. Then try adding a couple of your presets from the backup, using your computer.....

best

I

nickrose's picture
Eventide Staff
nickrose
Joined: Jan 17 2008
Posts: 4598
nickrose
October 28, 2009 - 11:05 am

The parameter freeze issue has been fixed in V4.01 which is now available.

davestejna
Joined: May 12 2008
Posts: 4
davestejna
October 28, 2009 - 12:36 pm

Just installed it and it seems to have fixed the issue. Thanks so much for the quick update! - tThis was a show stopper for me.