You are here

Bypassing the TF and MF through midi

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

2 posts / 0 new
Last post
catvomit
Joined: Nov 16 2008
Posts: 1

Bypassing the TF and MF through midi

catvomit
November 17, 2008 - 06:15 pm
Hello all. I know this has been covered through other threads, but I still can't seem to get an answer in regards to my current setup. My setup uses Voodoo Lab's ground control pro as a controller and the LF and TF are connected through MIDI. I'd like to bele to use one button changes for patches (example - hit one button and it turns on/off certain pedal loops, as well as changes patches on the MF and/or TF). My question is how to bypass the MF and/or TF independent of one another. I realize I can send a CC message from the Ground Control Pro to Bypass one of the pedals, but wouldn't this be sent to the next pedal (MF) through MIDI and bypass it as well? How can I send a bypass message to one through MIDI without affecting the other?
IDeangelis
Joined: Jan 9 2008
Posts: 1470
IDeangelis
November 18, 2008 - 03:17 am

Hello

CCs can be sent on different MIDI Channels. You can set the 2 pedals on different MIDI channels and use the same MIDI CC on different ch. It's always good to have units on different channels in a multi-units setup when using MIDI.

best

I