You are here

encoder / tap switch behavior

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

4 posts / 0 new
Last post
teddybutter
Joined: Jan 18 2008
Posts: 22

encoder / tap switch behavior

February 06, 2008 - 01:22 pm
Hi, I encountered some ineffective behavior with the encoder and tap switches... having trouble going into system mode by pressing both, then inside system mode having trouble with the encoder button push not registering. is this a hardware or software issue? Teddy
teddybutter
Joined: Jan 18 2008
Posts: 22
February 06, 2008 - 01:36 pm
also... I am using an AUX switch in ALT mode with the new beta software. When I use the bank up function from the aux sometimes it decides to be a tap switch. strange.... beta 2.0 firmware, Digitech FS3XV
nickrose's picture
Eventide Staff
nickrose
Joined: Jan 17 2008
Posts: 4353
February 08, 2008 - 02:43 pm

It sounds as if you have multiple features assigned to the AUX switch, with both FS3 (ALT mode switch 3) and BK+ (bank up) assigned to the same switch.

 If you are in bank mode and you press this switch, you will get both the PLAY mode function (tempo/delay) as well as the bank up. Both will work, but the result may be confusing.

 The solution is to go back to system mode and make sure that you only have one function set to each AUX switch.

nickrose's picture
Eventide Staff
nickrose
Joined: Jan 17 2008
Posts: 4353
February 08, 2008 - 02:45 pm

 There is a bug in 2.0 beta where the encoder switch has to be pressed twice to enter AUX switch programming mode. This will be fixed in the forthcoming next beta release.