You are here

Rose Volume Boost

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

3 posts / 0 new
Last post
stark
Joined: Jun 2 2020
Posts: 6

Rose Volume Boost

stark
January 17, 2021 - 02:42 pm

Input switch set to guitar, Bypass set to Relay, there is a big volume boost on bypass. Bypass set to Buffer, predictably both In/Out are boosted no level difference. Any way to adjust the gain to match the Relay Bypass?

joecozzi's picture
Eventide Staff
Check out my Eventide Gear
joecozzi
Joined: May 19 2015
Posts: 155
joecozzi (My Eventide Gear)
January 17, 2021 - 02:59 pm

Are you going into a guitar amp or a line-level device? Typically, when you experience a volume difference when in Relay mode it's because there's an impedance mismatch between the "Guitar" signal and the input of the device. This can also happen if the cable from the pedal to the amp is very long.

To answer your question, other than the line/guitar switch, there's no way to adjust the gain to match. You would have to use a preamp in between the pedal and the input of your next device.

stark
Joined: Jun 2 2020
Posts: 6
stark
January 17, 2021 - 03:03 pm

Right into amp, no other pedals. I understand the pedal buffer will effect the signal, but there still is a significant gain boost. Cable length is not an issue.