You are here

TimeFactor Billboard display

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

3 posts / 0 new
Last post
Sonogram
Joined: Feb 6 2019
Posts: 2

TimeFactor Billboard display

February 06, 2019 - 05:30 pm

I've just acquired a TimeFactor delay. Is it possible to change what is shown in the Billboard display after knobs have been used to change parameters? At the moment, once a parameter has been changed, the display returns to the name of the effect, 'DigitalDelay', 'VintageDelay', 'TapeEcho' or whatever. I would like to see the value of the parameter I have just changed displayed until another parameter is changed. Is that possible? Thanks.

nickrose's picture
Eventide Staff
nickrose
Joined: Jan 17 2008
Posts: 4279

Sorry - this is the way it

February 08, 2019 - 11:45 am

Sorry - this is the way it was intended to work. If you change a parameter its value is displayed for a few seconds, then it goes back to what it was doing before.

 

Sonogram
Joined: Feb 6 2019
Posts: 2

nickrose wrote:

February 10, 2019 - 07:43 am

nickrose wrote:

Sorry - this is the way it was intended to work. If you change a parameter its value is displayed for a few seconds, then it goes back to what it was doing before.

 

Thanks for your reply. It would be useful if a parameter change could remain until another change or at least remain in the display for a little longer. It disappears very fast. Maybe this might be considered in the next software updates.