You are here

Using two amps with Time Factor

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

3 posts / 0 new
Last post
Mauikihei
Joined: Sep 8 2012
Posts: 1

Using two amps with Time Factor

Mauikihei
September 08, 2012 - 02:38 pm

I am using two amps with the pedal to maximize the stereo effect.  Ois a Fender Deluxe and the other is a solid state Crate amp.  The Deluxe works fine but the other amp does not seem to work well.  The volume of the 2nd amp is always lower than it is when I plug directly into it.  Is there some reason that the volume feed into the two amps is different?  Can it be adjusted?

achaput's picture
Eventide Staff
achaput
Joined: Jan 9 2008
Posts: 557
achaput
September 10, 2012 - 06:08 pm

Hello,

Have you tried adjusting the Dly mix knob? This controls the balance between the two outputs.

arcadesonfire
Joined: Feb 13 2008
Posts: 36
arcadesonfire
September 16, 2012 - 04:30 am

Maybe check the switch on the back of the TF to make sure it's set to amp level for the output, rather than line level.

If that's not the problem, then I'm wondering if you mean the whole level--including the dry--is lower out of the Crate than the Fender? If it's just the wet that's lower, then I'm guessing it's because the tube amp is compressing more than the crate? I use my TF through a Fender Hot Rod Deluxe set to sound clean and through a Marshall Plexi clone set to light overdrive. The delays compress (upwards) a lot more in the overdriven amp, so they sound louder.