You are here

V3 Preset Names

Login to Post to Forums

You must be logged in to the Eventide website in order to post to our forums. If you do not have an account, you will need to create one. You may also reset your password.

4 posts / 0 new
Last post
rabiddiabetic13
Joined: Sep 30 2009
Posts: 109

V3 Preset Names

rabiddiabetic13
December 03, 2010 - 01:51 pm

Hi,

I noticed that not all the preset names made it onto some of the patches on all the factor models. The display reads as before on some patches with the effect name appearing first (Chorus) then the bank info (2:1).  Is this because these patches parameters might have been changed and saved from the original preset?

This is not a problem for me because I' m probably one of the few that does not care about patch naming and actually like the display as it was before.  

So my question is can I make all the patches read as before with effect name first then bank #?

Also asked about getting spillover for Undualtor at bypass on V3. It  did not seem to make the cut any chance it will on future update?

Thanks for the support and new SW versions.

timothyhill
Joined: Dec 2 2010
Posts: 356
timothyhill
December 03, 2010 - 02:45 pm
+1 for Undulator spillover... I'm guessing that the missing preset names will be updated before the final release of V3. I initialized all my pedals before installing, so in my case, there shouldn't have been any changed patch parameters, but you could be correct about that being part of the reason... I hope that the Undulator spillover will make it to a future update. I wouldn't think that would be too difficult to do, since both PF & TF support spillover. MF wouldn't need it, but Undulator isn't just modulation and could greatly benefit from spill... -Tim
JNPMusic
Joined: Jan 21 2008
Posts: 53
JNPMusic
December 04, 2010 - 11:06 pm

I noticed that the names didn't show up on any preset that I altered. Maybe because it was altered that the names don't remain as well.....?

damienl64
Joined: Feb 1 2009
Posts: 29
damienl64
December 05, 2010 - 04:27 am

Same here preset names are not saving properly as they keep the bank number (eg a preset named spring will display 2:1 spring).