You are here

DynaVerb

DynaVerb couples an Eventide Eclipse reverb with a model of the Eventide Omnipressor® to create an adaptable dynamics reverb. The Omnipressor is capable of all types of dynamics processing from gating, expansion, compression, limiting and even its signature "dynamic reversal," where loud signals are squashed, but quiet signals are amplified. In DynaVerb, the Omnipressor can dynamically control the output of a reverberator based on, either the input signal for maximum control, the reverb output for incredible chaos, or any mixture of the two. As an added bonus DynaVerb can also be used as a standalone Omnipressor by setting [DECAY] to zero.

H9 Control View - Click (+) for more info

DynaVerb Algorithm Controls
Mix [MIX]
wet/dry mixer, 100% is all wet signal
Decay [DECAY]
decay in seconds or note-based in Tempo Mode, when decay is 0, this effect can be used as a standalone Omnipressor or gate
Size [SIZE]
room size of reverb
Attack Time [ATTACK]
attack time of Omnipressor/gate in seconds
Low Band Shelving Level [LO-LVL]
post reverb shelving boost/cut of low frequencies with cut-off at 350 Hz
High Band Shelving Level [HI-LVL]
post reverb shelving boost/cut of high frequencies with cutoff at 2000 Hz
Compression/Expansion Ratio [ORATIO]
ratio control for the Omnipressor from traditional Gated sound, to expansion, then compression, then limiting and infinite ducking, then to negative ratios which result in dynamic reversal.
Release Time [RELEAS]
release time for the Omnipressor/gate in seconds
Threshhold [THRESH]
threshold for the Omnipressor/gate
Sidechain [SCHAIN]
the mixer to sidechain input (gain control signal). When set to minimum, the gain curve is derived from the input only. At maximum, it is a feedback dynamics unit with gain derived from the reverb output. In OMNIMODE, this simply lets you fade between a feedforward (FF) and feedback (FB) compressor/expander/gate/etc.
Output Level
At 0 the output level is unaffected. Increase the output level of the effect by up to 20 dB or lower by 30 dB.
TEMPO ON / TEMPO OFF
Tempo is turned ON/OFF on the H9 by simultaneously pressing the Right Footswitch and the PRESETS button. With Tempo OFF, tapping can be used to adjust delay parameter values (displayed as milliseconds or Hz). With Tempo ON, tempo is in BPM.
Active
Turn effect on or off..
HotSwitch
The Middle Footswitch can be programmed to act on the loaded Preset as a programmable controller allowing the user to switch between the normal Preset parameter values and a programmed, alternate set of parameter values. It’s like having two Presets in one.
TAP
If Tempo is ON, the display indicates the current tempo in BPM (30 to 500 BPM) while tapping and the Tap LED will blink at the BPM rate. If Tempo is OFF, the display indicates the parameter value (milliseconds for most algorithms).