You are here

Filter Pong

Videos

H9 Control View - Click (+) for more info

Filter Pong Algorithm Controls
Mix [MIX]
wet/dry mixer, 100% is all wet signal.
Delay Mix [DLYMIX]
Controls the relative level of the twin delays, Delay A/Delay B. The H9 has circuitry that detects which input/output jacks are being used and adjusts the routing of signals through the Effects algorithm accordingly. [DLYMIX]’s mixing behavior depends on whether you’re using mono or stereo outputs. For Mono Out, with [DLYMIX] = 0, Out 1 will have only Delay A’s contribution. With [DLYMIX] = 50%, Out 1 has an equal amount of Delay A and Delay B. With [DLYMIX] =100, Out 1 will have only Delay B’s contribution. For Stereo output, with [DLYMIX] = 0, BOTH outputs will have only Delay A’s contribution. With [DLYMIX] = 50, Delay A goes to Out 1 only and Delay B goes to Out 2 only. With [DLYMIX] = 100%, BOTH outputs will have only Delay B’s contribution.
Delay A [DLY-A]
Sets delay time for Delay A output from 0 to 3000 mSec. With Tempo OFF, delay is displayed in mSec. With Tempo ON, delay can be sync’d to the tempo and is displayed as a rhythmic sub-division of the tempo beat value - changing this from 0 to a whole note in common note increments.
Delay B [DLY-B]
Same as A.
Feedback A [FBK-A]
Controls level of Feedback A, the number of repeats. The FilterPong Effect is created by cross connecting the feedback paths of the twin delays. As a result, only a single feedback control is needed.
Diffusion (Slur) [SLUR]
Controls the diffusion (SLUR) of the repeats. With low diffusion the repeats are discrete. Increasing diffusion slurs the repeats.
Modulation Wave Shape [SHAPE]
Selects the 'shape' of the filter modulation.
Modulation Depth [DEPTH]
Sets the filters’ amount of frequency modulation.
Modulation Speed [SPEED]
Speed multiplier for filter modulation.
Filter [FILTER]
Controls the mix of dry/filtered signal input to ping-pong delay.
Output Level
At 0 the output level is unaffected. Increase the output level of the effect by up to 20 dB or lower by 30 dB.
TEMPO ON / TEMPO OFF
Tempo is turned ON/OFF on the H9 by simultaneously pressing the Right Footswitch and the PRESETS button. With Tempo OFF, tapping can be used to adjust delay parameter values (displayed as milliseconds or Hz). With Tempo ON, tempo is in BPM.
Active
Turn effect on or off..
Repeat
Press and hold for infinite repeat.
TAP
If Tempo is ON, the display indicates the current tempo in BPM (30 to 500 BPM) while tapping and the Tap LED will blink at the BPM rate. If Tempo is OFF, the display indicates the parameter value (milliseconds for most algorithms).