Space Killdry off but no dry signal from Timefactor loop

This topic is empty.

Viewing 3 reply threads

Author

Posts
- December 29, 2018 at 6:02 pm #115127
  knifey
  Participant
  Hi,
  
  I’m working some live sound design for a theatre production and I have a synths going into a mixer, aux sending into a Timefactor as looper and then to a Space, in series (Timefactor —> Space). Both pedals have Killdry set to “NO”. When I record a loop in the Timefactor and it plays back, the Timefactor loop will NOT pass through the Space when the Space Mix knob is set to 0 (fully CCW). However, signals from my mixer is still passing through. I’m not sure what setting I have wrong as I was expecting both the recorded loop and live signals from the mixer to be passing through. It seems weird to me but I must have something set incorrectly.
  
  Any help much appreciated!
- December 31, 2018 at 3:32 am #150899
  bohan
  Moderator
  Eventide Staff
  knifey wrote:
  
  Hi, I’m working some live sound design for a theatre production and I have a synths going into a mixer, aux sending into a Timefactor as looper and then to a Space, in series (Timefactor —> Space). Both pedals have Killdry set to “NO”. When I record a loop in the Timefactor and it plays back, the Timefactor loop will NOT pass through the Space when the Space Mix knob is set to 0 (fully CCW). However, signals from my mixer is still passing through. I’m not sure what setting I have wrong as I was expecting both the recorded loop and live signals from the mixer to be passing through. It seems weird to me but I must have something set incorrectly. Any help much appreciated!
  
  Is the MIX knob of your TimeFactor set to 50 (middle)?
- January 31, 2019 at 4:08 am #151160
  knifey
  Participant
  Hi,
  
  Yes, my Timefactor knob is always set to 50%.
  
  So – I just tried all 3 Bypass modes and the problem is still this: If (in Play mode) the Space is bypassed, I can hear the Timefactor loop playing, no problem. When the Space is active, I hear nothing when the Mix knob is fully counterclockwise. Is that normal?? I thought I’m supposed to hear the dry signal even when the pedal is active.
  
  Thanks a lot.
- January 31, 2019 at 5:16 am #151161
  knifey
  Participant
  User error! I did not check the Routing in the Space and it was set to Wet/Dry instead of Normal. Hence, when the pedal was Active, Mix knob showed “Wet 0” and dry signal was muted.
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.