H90 after amp modeler/profiler

Home › Forums › Products › Stompboxes › H90 after amp modeler/profiler

Viewing 2 reply threads
  • Author
    Posts
    • May 28, 2025 at 4:49 pm #190373
      user404
      Participant

        I would like to use my h90 after modeler (dime head namplayer) because I want stereo delay

        unfortunately dimehead loop is mono, that’s why I need to put h90 after the profiler

        first question: do I need to set the input of h90 as line input?

        second question: what I need for to play with headphones?

        dimhead has headphone output, but if I put h90 after I cannot use it

        thanks

         

      • May 28, 2025 at 7:21 pm #190379
        apalazzolo
        Participant

          hi,

          you have a lot of configuration options and i’m sure you’ll soon get great advice on that from the experts here (so i’ll leave that to them).

          i came to say that i’ve been using quality headphones plugged into the stereo outputs of the H90 for two years and it has always worked great.  i use a basic Y-adapter and my headphones are considered low impedance (24 ohms).  i’m using denon ah-5200 but i expect any quality headphones will be fine. but i also suspect that headphone use is not recommended by Eventide.  so there’s that.

          i boost the output of the H90 to +12 dB to drive the headphones and that parameter is called “P out”.   it’s just the right volume for me and it is crystal clear.

          good luck!

           

           

           

           

           

           

           

           

        • May 29, 2025 at 2:53 am #190382
          user404
          Participant
            apalazzolo wrote:

            hi, you have a lot of configuration options and i’m sure you’ll soon get great advice on that from the experts here (so i’ll leave that to them). i came to say that i’ve been using quality headphones plugged into the stereo outputs of the H90 for two years and it has always worked great. i use a basic Y-adapter and my headphones are considered low impedance (24 ohms). i’m using denon ah-5200 but i expect any quality headphones will be fine. but i also suspect that headphone use is not recommended by Eventide. so there’s that. i boost the output of the H90 to +12 dB to drive the headphones and that parameter is called “P out”. it’s just the right volume for me and it is crystal clear. good luck!

            i will try, thank you

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.