Having a problem. For a long time I had my ML10X and pedalboard set up so that the ML10X tip input/output ran through some pedals, including into and out of my H90 (on input 1 and output 1 on one of the ML10X’s loops, C ring for what it is worth).
Then I ran the the ML10X ring input/output through my H90’s insert loop. H90 output 3 –> ML10X ring input and ML10X ring output –> H90 input 3.
This worked.
I rewired the board recently (to use sleeker insert cables), and I tried to keep everything as is. But I’m getting unexpected behavior. Essentially, whether or not the H90’s effects are applied to my depends on where the insert is in the H90’s routing menu. If the insert is placed before both effects of the H90, I hear both H90 effects. If the insert is between them, I only hear the latter effect. If the insert is after them, I don’t hear either effect.
I cannot wrap my mind around why this is happening, it doesn’t make any sense. Any suggestions?
.
