MixingLink weak signal/too much gain required

This topic is empty.

Viewing 3 reply threads

Author

Posts
- March 10, 2018 at 6:56 am #114645
  mistercharlie
  Participant
  I’ve found that my MixingLink needs to have the input gain turned up quite high to get unity gain through to a guitar amp.
  
  Signal path:
  
  Guitar>Inst In>To Amp>Amp
  
  I’m not using the MixingLink FX loop or anything else (although I get the same issue if I do). The gain switch on the side is set to ‘low’. Setting it to ‘high’ results in way too much gain.
  
  If I have the Input Gain and the Phone & Amp Level knobs set to 12 o’clock, the output signal is a lot quieter than just running a guitar straight into the amp. To make the level match, I have to turn the Input Gain up to 2 o’clock. This also introduces a small level of hiss.
  
  Is this normal?
- March 10, 2018 at 7:04 am #148629
  JWaltz
  Participant
  Hi Charlie – You should be able to set Input Gain so the loudest input level flashes the green signal present. Then set Ouput Level for unity.
  
  The Mix Mode setting will also have an effect on the unity gain setting.
  
  Hope this helps
  
  joe waltz
- March 10, 2018 at 7:06 am #148630
  mistercharlie
  Participant
  Thanks Joe,
  
  I’ll play with the levels some more. How do the Mix Mode settings affect unity gain?
  
  C
- March 17, 2018 at 5:44 pm #148690
  mistercharlie
  Participant
  Solved. The problem was a dodgy cable! The cable works fine in other pedals, but was causing problems when plugged into INST In on the MixingLink. I switched it for another one and the MixingLink works as it should, with unity gain at 12 o’clock and no hiss.
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.