Entrainer:

So here goes the temp dream routing-

Firewire in- 1&2 direct to Analog 1+2 out.  That's my dry feed from DAW that I want to monitor.

Firewire in- 3&4 to proc A.  Processor A outs to Firewire out 3&4

Firewire in 5,6,7,8 to proc B, Proc B to Fire Out 5-8

1) First you must select FWIRE 1-8 as inputs 1-8. Do this an input at a time (sorry) on [SETUP] [inputs].

2) Then [DSP A]. Down arrow twice to select the first 2 inputs. Turn wheel to select FWIRE 3&4.

3) Then [DSP B]. Down arrow one to select first 4 inputs. Turn wheel to select FWIRE 5-8.

4) Then [output]. Down arrow once to select first twon inputs. Turn wheel to select FWIRE 1&2. This connects FWIRE 1&2 to the first 2 main outputs. These are analog 1&2.

5) Then down arrow 3 times to select the seconds pair of outputs. Turn wheel to select "dsp A out 1"-2. This connects these to MAIN out 3 &4, which we will need to feed the FWIRE outs 3-4.

6) Then, [output]. Turn wheel until you see "dsp A out 1"-4. This connects these to MAIN outputs 5 -8, which we will need to feed the FWIRE outs 5-8.

7) Now, [output] 3 times to display FIREWIRE 1 outputs. Down arrow 5 times to select OUT 3-4. Turn wheel to select MAIN out 3-4, which we set up in (5) above.

8) Now right arrow to select OUT 5-8. Turn wheel to select MAIN out 5-8, which we set up in (6) above.

Spelling it out like this makes it look much more tedious and difficult than it actually is, but you get the idea …