Home › Forums › Products › Stompboxes › H90 Tuner MIDI assignment
- This topic has 8 replies, 4 voices, and was last updated 1 year, 5 months ago by gas hed.
-
AuthorPosts
-
-
November 20, 2022 at 12:54 pm #166889gas hedParticipant
Trying to figure out why I can’t “turn on” my tuner via my Morningstar. I’ve set up the tuner in the H90 external control menu as shown below. Sending message 0 doesn’t work. Anything I should be aware of? I have the H90 as MIDI channel 2 and the Morningstar program change is showing that as well.
-
November 20, 2022 at 1:23 pm #166893coirbidh_99Participant
You haven’t actually assigned the control – Control Source “off” means there’s no assignment for that parameter. Change the pull-down to MIDI and assign a CC number. Send value 127 to that CC on MIDI channel 2 to turn the tuner on/off.
-
November 20, 2022 at 1:32 pm #166894
Actually, your MIDI assignment is correct here. Under “Control Source” where it says Off that is referring to Aux switches and Exp pedals.
I believe this is an issue with your MIDI controller setup, can you confirm it is actually sending CC# 0 with a value of 64 or higher? You can use a MIDI monitor to confirm this.
I can turn the tuner on/off with CC #0 so it seems that the issue is somewhere in your setup. You can also turn on “Receive Omni” on the H90 and that will make it easier to troubleshoot if your controller is not using the correct MIDI channel.
-
November 20, 2022 at 1:34 pm #166895coirbidh_99Participant
D’oh! That’s what I get for making logical suppositions about software I haven’t used extensively yet. Crawling back under my rock now….
-
-
November 20, 2022 at 8:30 pm #166900gas hedParticipant
Hmmm, this is troubling…I can’t seem to figure it out. Here is my midi set up:
I tried using Control Change for Type as well as Program Change but no dice. 🙁
-
November 21, 2022 at 7:54 am #166904gas hedParticipant
MIDI Monitor checks out. Wondering if the H90 needs a specific “Type” of message to send to engage the tuner?
-
November 21, 2022 at 8:11 am #166906coirbidh_99Participant
Try sending CC 0 with a value of 127 and see if that works.
-
November 21, 2022 at 8:22 am #166907frankie138Participant
I have this working on my MC6, screenshot of settings attached.
Make sure the CC value is over 64 and position is set to ‘both’ (at least that has worked for me).
Attachments:
You must be logged in to view attached files. -
November 21, 2022 at 10:45 am #166909gas hedParticipant
Ahhh, that worked frankie138 – thanks man!
-
-
AuthorPosts
- You must be logged in to reply to this topic.