Pitchfactor Stereo to mono

Home › Forums › Products › Stompboxes › Pitchfactor Stereo to mono

Viewing 5 reply threads
  • Author
    Posts
    • April 10, 2023 at 1:47 am #170333
      manuelroland
      Participant

        Hello,

        I’m using my PF in stereo with two amps. I really dig the stereo for most of the sounds I use but for specific sounds, I would like to be in mono. So I would like to have both amp playing the same.

         

        Is there a way to force a preset to be in Mono and let the others stereo ?

         

         

      • April 10, 2023 at 8:10 am #170335
        brock
        Participant

          Pretty sure the PitchFactor senses the physical cabling to determine mono or stereo.  Maybe something like the Boss LS-2.

        • April 10, 2023 at 8:49 am #170337
          joecozzi
          Moderator
          Eventide Staff

            This is not possible on a preset basis.

          • April 10, 2023 at 1:02 pm #170347
            manuelroland
            Participant

              OK, too bad. Hope there will be an update. thank you

            • April 12, 2023 at 10:42 am #170396
              manuelroland
              Participant

                But in the Manual, page 51 there is this sentence

                “STEREO – this is the normal operating mode where both channels are Wet unless bypassed. It is here to allow you to return to normal stereo mode on a preset by preset basis. For example, in a two amplifier setup, you might want a shifter to come from one amp, but a reverb to feed both.” 

                Thats exactly what I want to do. On one of my preset I want the effect to be on both amp. In this sentence, it looks like it is possible

              • April 12, 2023 at 11:03 am #170397
                joecozzi
                Moderator
                Eventide Staff

                  This part of the manual is taking about routing modes. If you set the PitchFactor’s routing mode to Wet/Dry, this means ONLY one side will get a mono version of the effect, but not both. You get to decide which side with Wet 1 (Out1 wet) and Wet 2 (Out 2 wet). The other side is always dry. If you set a preset to Stereo, the pedal operates like normal, not mono.

              • Author
                Posts
              Viewing 5 reply threads
              • You must be logged in to reply to this topic.