Hi,

Ok i will go back to my initial setup in DUAL MODE with some slight changes, i ditched the Lehle isolator because the Radial also does the same job.

i will put the H90 first mono signalpath in loop 2 of the switcher by connecting the send and the return of the switcher and connect it to H90 Input 1 and output 1.

The second stereo part will be my stereo signal in loop 12. This loop consist of an H9, the H90 itself, The Big Sky reverb and a Nux stereo looper pedal which i will connect as below.

SEND LOOP 12 SWITCHER > H9 input

H9 OUT L > H90 INPUT 3

H9 OUT R > H90 INPUT 4

H90 OUTPUT 3 > BIG SKY L INPUT

H90 OUTPUT 4 > BIG SKY R INPUT

BIG SKY L OUT > NUX L INPUT

BIG SKY R OUT > NUX R INPUT

NUX L OUT > Switcher return L

NUX R OUT > Switcher return R

So now the H90 is connected in TWO loops of the switcher, LOOP 2 mono and LOOP 12 in stereo.

Loop 2 is early in the looporder of the switcher and the stereo loop 12 is the last one in the looporder.

So when everything works out fine this will probably be the most flexible routing for me right? Regardless of musical taste.

I will do so after a confirmation from your side as this is much work and i want to make sure this works 100% before i tear my pedalboard upside down again 🙂

Thanks in advance.

Best regards, Collin