H90 Control – How do you select algorithms for an unit patch?

Home › Forums › Products › Stompboxes › H90 Control – How do you select algorithms for an unit patch?

Viewing 2 reply threads
  • Author
    Posts
    • December 4, 2022 at 3:34 pm #167402
      ima_jrk
      Participant

      I literally can’t figure this out. Software shows two Thru algos. Where do I see a list of algorithms to choose from?  Is the only way to start from a program and edit?

    • December 4, 2022 at 3:43 pm #167403
      ima_jrk
      Participant

      Nevermind – I finally figured out that it was a preset and that it seems you can’t select an algorithm directly in an init state.

    • December 4, 2022 at 4:39 pm #167404
      brockstar
      Participant

      Go to library and then click on the preset name at the top in slot A and then choose one of those presets in the preset list and it’ll change for slot A and then do the same for slot B etc. Same applies for INIT / blank programs.

  • Author
    Posts
Viewing 2 reply threads
  • You must be logged in to reply to this topic.