PitchFactor: Wet level at 100, but still hear dry

[RolloTomasi]

HI,

I have my PF wet level set to 100, but still hear the dry feed – in fact, the dry is louder than the wet.

I'm using FW 2.2.1 and running the PF into a Line6 Pod X3 Live using the effects loop (in case this helps at all).

Any help would be most appreciated.

Thanks!

[achaput]

Hello, could you try the PF without the Line6 just to make sure it's not the Line6 Effects Loop adding dry signal?

[RolloTomasi]

Sure.

Although Iw as wondering if using KILLDRY is the right way to go. However, when I enter System mode, I don't have [BYPASS] as an option to adjust. Has that been changed under 2.2.1?

[RolloTomasi]

Going around the FX loops works. I'd still liek to run the PF through the loop, though.

Is there some way I can activate KILLDRY? Following the instructions in my manual don't give me the option to turn it on or off. (I"m assuming Sevice mode is accessed a different way, now…)

Thanks!

[RolloTomasi]

Following your advice led me to all the answers I needed after all – Thanks!

[Author]

Posts