Ramp up value?

This topic is empty.

Viewing 3 reply threads

Author

Posts
- March 27, 2012 at 1:22 pm #108561
  jop
  Hello,
  
  I'd like to make a value ramp up from a starting value to an "end" value when I send a specific control change to the eclipse.
  
  Currently i have patched ext#5 to midi general 1 (CC 16).
  
  I modulate the SEND parameter of a pitchshifter with the ext5 and the value goes from 0 (off) to 100% (cc 127). I don't want to manually control it via an exp pedal. I tried using the LFO but it oscillates and can't do a "ramp up" when the CC is 127 and "ramp down" when the CC is 0.
  
  Using the ADSR would be not as much precise as I want. How should I do this?
  
  Thanks!
  
  J
- March 27, 2012 at 2:55 pm #123259
  nickrose
  Moderator
  Eventide Staff
  Sorry – I don't think you can do this with an Eclipse – you would need a 7600 or 8000.
- March 27, 2012 at 4:28 pm #123260
  jop
  I sorta did this with a dirty trick.
  
  I used the ADSR triggering with ch1 input volume. Then I patched the ext5 to the SEND parameter, starting from 50% to 100% with instant change. The ADSR is set to trigger with a send volume which is normally not attainable when it is at 50% – so when the CC sets the send volume to 100%, the adsr triggers and stay there while i'm playing, altering the m_level of the effect nicely. Of course I lowered the wet volume accordingly and could do this just because i'm using the eclipse in a dry/wet rig and only the wet signal is output by it.
  
  Thanks anyway
- March 27, 2012 at 5:00 pm #134358
  nickrose
  Moderator
  Eventide Staff
  I guess I should have said that I couldn't do it rather than you couldn't ….
Author

Posts

Viewing 3 reply threads

You must be logged in to reply to this topic.