For the good of eventideusers I'll publish the SliceSequencer so far. The operation is as follows:
From the Masterwindow the 16 step-values can be set (0-127 out). Setting any slider to 0 enables the respective submenu for taht step, so that values of subdivisions can be set ( possible divison are 2,3 or 4).
However, there are som timing is not very accurate and I suspect that this is because of of the Harmonizers only update the control signals at about 100 hz….. (the preset genrtes 12 pulses for ecach step to anble the subdivisionprocess) Any ideas on how to get better timing in this patch is appreciated,,,,(Nick or anybody?)
I suppose I could reduce the clocksteps within each step from 12 to 4 (ignoring tripletdivision), but it is not ideal…
Ole
