Hi folks, have mercy on me because I’m sure this is simple, I’m just a sandwich short of a picnic. As proof of that, I just accidentally posted this question first to the wrong sub forum (sigh, getting old).
I want to load a prg on the 7600 and have it stay in prg view, not go right into param view. I spent more than a few minutes looking through the manual with no luck (not saying the info’s missing, just that I didn’t find it). The “always accurate and dependable” Google AI (that was a joke, ok) says that when scrolling to a prg, don’t press “select” but instead press the “load” soft key – but there isn’t one – I’ve looked and looked. I also looked all through the setup pages and never saw anything that adjusted that.
If anyone can help, I’d sure appreciate it.
.
